Tips of reforming and improving old dust collector in flour mill

Tips of reforming and improving old dust collector in flour mill

Tips of reforming and improving old dust collector in flour mill: What problems will be encountered in the use of dust remover in flour mills? How to solve it? As dust filter bag manufacturer, SIIC introduces you about it.

In view of the dust disposal process in the flour mill, its dust is characterized by high temperature, flammable, explosive and dust emission. Our main recommendation is the bag filter.

What problems will be encountered in the use of dust remover in flour mills?

How to solve it? As dust filter bag manufacturer, SIIC introduces you about it as followings:

1-    The working efficiency of the dust removal equipment in the flour mill is decreasing, which is caused by the insufficient wind pressure of the fan in the dust collecting system.

2-    It is also important to check the wear of the filter bag. If the filter bag is found to be worn, the new filter bag should be replaced in time so as not to affect the dust collector effect.

3-    The suction effect of the key equipment should be ensured when selecting the suction point. The suction volume can be reduced on accessories, and the suction volume can also be cancelled if necessary.

4-    The leakage of the dust collector leads to the condensation. The causes of the air leakage of the dust collector are as follows: the welding effect caused by the welding process, the poor sealing effect of the discharger, and the air leakage caused by the tight sealing at the flange joint.

5-    If the wind speed is too low, it will cause the blockage of the dust collecting pipeline. When the wind speed is too high, the wear of the pipeline will increase, especially the turning point of the pipeline is most obvious.